carbon fiber rods

What are the fixing methods for carbon fiber product molding dies? (carbon fiber rods, carbon fibertubes , carbon fiber sheet)


  • Keyword
    carbon fiber rods
    carbon fiber fishing rods
    carbon fiber rod
    carbon fiber rod fishing
    carbon fiber fishing rod
    carbon fiber square rod
    solid carbon fiber rod
    carbon fiber solid rod
    fishing rod carbon fiber
    pultruded carbon fiber rod
    carbon fiber fishing rod blanks
    carbon fiber rod blanks
    carbon fiber rods for sale
    carbon fiber square rods
    hollow carbon fiber rod
    best carbon fiber fishing rods
    buy carbon fiber rods
    carbon fiber spinning rod
    custom carbon fiber fishing rods
    0 8mm carbon fiber rod
    carbon fiber baitcaster rod
    carbon fiber fly rod
    carbon fiber rod grips
    best carbon fiber cleaning rod
    carbon fiber fishing rod grips
    carbon fiber fly rod grip
    solid carbon fiber rods
    3mm carbon fiber rod
    carbon fiber casting rod
    carbon fiber kite rods
    carbon fiber rod tube
    carbon fiber rods and tubes
    carbon fiber rods near me
    carbon fiber vs graphite fishing rod
    graphite vs carbon fiber fishing rods
    4mm carbon fiber rod
    5mm carbon fiber rod
    carbon fiber fishing rod repair kit
    carbon fiber fly rod blanks
    carbon fiber neck rod
    carbon fiber telescopic fishing rod

method 1

On each side of a molding die, weld a support. Weld then a column, and then a tie-rod at the respective positions on either side of the vibrating table. Use a pressplate on each side of the vibration table to press both the columns and support plates on the molding das simultaneously

method 2

Form a boss by welding a thick plate of steel (which has the same cross-sectional shape as the inner section of the mold die) to the vibration table. Note that the lower edge does not touch the tabletop directly. The molding die is held in place outside the vibrating table by crossbeams on both sides and positioning columns. The molding die is barely vibrated during vibration molding

method 3

Install electromagnets into the frame of the tabletop vibration table. The mold is held in place by electromagnetic attraction. After the force has been removed, it can be removed

Leave a Comment

Your email address will not be published. Required fields are marked *

Shopping Cart
Scroll to Top